Position in the file

Devan_LT · 18-11-2008 20:53

I want to choose current position in the file (position that data is read from). Is it possible? If not, could an opcode be created in the next version of CLEO?

Seemann · 19-11-2008 12:18

0AA5: call 0x538990 num_params 3 pop 3 $from $offset $file

$file - file pointer
$offset - Number of bytes from $from
$from - Initial position (usually 0)

Devan_LT · 19-11-2008 14:17

Thanks! But I don't understand a little bit. Does it sum $from and $offset or what?

Seemann · 19-11-2008 14:49

yes, it could be said that it sums $from and $offset

Devan_LT · 19-11-2008 15:28

Thanks again smile

listener · 19-11-2008 18:42

@Devan_LT

$from defines starting point:

0 - seek from start of the file;
1 - from current position ($offset can be negative)
2 - from end of file

Devan_LT · 19-11-2008 22:40

Ok, now I understand this, thanks smile

SannyBuilder.com Forums

#1 18-11-2008 20:53

Position in the file

#2 19-11-2008 12:18

Re: Position in the file

#3 19-11-2008 14:17

Re: Position in the file

#4 19-11-2008 14:49

Re: Position in the file

#5 19-11-2008 15:28

Re: Position in the file

#6 19-11-2008 18:42

Re: Position in the file

#7 19-11-2008 22:40

Re: Position in the file

Board footer